Posted by pms on January 19, 2019 at 20:01:49 from (216.161.81.229):
I've been looking for a small dozer to buy,so today I go look at a 1959 TD6 with a factory turbocharged D282(kinda rare).It looked to be in pretty good condition.I get there and the owner gets out a can of huff to start the thing,its fifty degrees today.Before he tries to start it I tell him this engine has glow plugs,he says really?Then I show him the glow plug meter on the dash and I push the button for the glow plugs and it pegs the meter like it's supposed to.He says wow! my dad and I have owned this dozer for over fifty years and neither one of us knew that!I'm thinking to myself this can't be good.So he hits it with huff and then hits the start button and engine fires up and its maybe running on one or two cylinders then it picks up another one or two cylinders,so then its maybe running on five cylinders.And that's as good as it got and all the while it's smoking pretty good too.I tell him the engine has a dead hole,and he says it has ran this way since they had it!Told him I'm gonna have to pass on this one(thinking broken rings or worse).It's a real shame to ruin an otherwise good engine just by simple ignorance and/or not knowing the proper srarting procedure for this engine.I used to own a IH 656 with the same D282 engine and unless engine is warmed up good this engine requires using the glow plugs.Again what a shame.Don't understand how someone could not know their machine better than that but I also wrench for a living and have seen lots of issues from simple neglect.Ok rant over...job security right?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
