Tractor Talk Discussion Board |
Re: Old Tractors=$?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Raider on August 18, 2001 at 07:42:24 from (208.188.18.241):
In Reply to: Old Tractors=$? posted by Harry on August 17, 2001 at 22:10:53:
I would think there are many parts that could be made by you. One comes to mind is a water pump impeller and shaft on a Farmall H & M. The shaft wears and you're left with a good but useless impeller. And CaseIH wants a fortune for the new part. Another one would be the axle pin on a 9N. They always need building up and turning. They don't make the pin for the 9N like they do for the 8N. Try posting on all the boards here for the special part idea and see what you get. I don't see it as an advertisement. Casting would be interesting, most people give up when they need an impossible to find casting. Now if you could cast a N series block!?
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|