Tractor Talk Discussion Board |
Re: Cletrac won't start! HELP!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on July 25, 2001 at 05:11:31 from (209.47.89.114):
In Reply to: Cletrac won't start! HELP! posted by Mark on July 24, 2001 at 20:54:43:
First, let's assume that the points, condensor, etc. are all installed properly and the mag is timed correctly. There are articles in the archives on timing magnetos. If you had the mag out, you might be totally out of time, or even experienced mechanics can get it easily 180 degrees out thinking that it's correct. Backfiring would indicate that you might have a timing problem. When you replaced the plug wires, did you use the older type "metal strand" wires? If you used the newer type (carbon/silicon or whatever it is that they use), then chances are you aren't getting enough fire through those to give a good spark. I've been told that the old electrical systems do not function with enough voltage to work properly with the new wires. If you're making up a new set of metallic wires, make sure you solder the brass connections.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|