Tractor Talk Discussion Board |
Re: Oliver super 55, clutch problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Larry on July 24, 2001 at 09:41:16 from (208.10.124.68):
In Reply to: Oliver super 55, clutch problem posted by Eddie Fowler on July 23, 2001 at 17:40:04:
There could be a number of things happing here.The throwout bearing maybe sticking on the tube,oliver had an add on grease kit for this.One problem i have had is with the rebuilt preasure plates sometimes the finger will crack right in the hinge point.Everythings looks ok but it wont relese the clutch.It takes dissambly and a good set of eyes to find it.You can try to adjust the clutch fingers again,and they will look ok.When you try to use it the crack will open and the clutch will be stuck again.You must replace all the fingers with new to stop this.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|