Posted by jeffcat on December 01, 2018 at 13:08:57 from (50.207.7.237):
In Reply to: Anyone like old saws? posted by Morgan in ar on December 01, 2018 at 10:36:29:
I have a decent size collection of Mc Culloch saws. Goes all of the way back to the mid 50s. Goes from 2.1cc all the way up to the big 6hp mac 1000 with a 4.5 foot long bar. That 605 is the smallest of the 600 series saws. They are a little rare. I only have one in my collection. I think it is 3.5cc. Good running saws and I will tell ya Please run it with hi-test gas and mix a bottle of fuel mix in 3/4 gallon of gas so you end up with about a 36/1 mix of fuel. Saw is much happier with that mix. The other thing is use straight 30wt motor oil in the bar oil tank. That saw has a diaphram type pump and that sticky bar oil just will not pump. Another person was saying about his 10-10 saw getting run over. There are several models of 10-10 saws from a light weight to a semi pro model called a 555. That is the one he wants to get hold of. That or a pro mac 650. I have nine or ten of those and three of them have bow bars on them. It is the top of the 600 saws and has compression release and is 3.7cc. That is around 4hp of raw power! The big monster in the collection is a two man Disston saw. Model KB-7B. That is two cylinders at 12hp. Have you ever checked out this web site? "Chainsaw Collectors Corner" out of Canada. Has every single chainsaw ever made. Loads of information. Have fun with your new toys. P.S. go on Ebay and pick yourself up a set of teeth for that saw. Night and day difference how it will cut. Also way less chance of kick back.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
