Posted by redforlife on November 09, 2018 at 16:59:03 from (68.234.121.189):
In Reply to: A cow to eat.... posted by jl ray on November 09, 2018 at 07:12:30:
A cow is not really a good thing to butcher. Unless you want hamburger and intend on grinding the whole thing into hamburger. If you want good steaks and roasts, you need to buy a good beef steer or heifer calf and raise it to adult size, 1200 to 1300lbs. Approximately 2 years old. Jersey's can be buthchered about 900 to 1000 lbs. They don't get much bigger than that. Holstiens probly need to be butchered around 1300 to 1400lbs. Holstiens have a bigger frame and bigger bone structure. So they need to be raised bigger to end up with the meat you should get.
When raising a calf for butcher, a new born calf should be fed milk to start with for a couple three months. I like to put at least 2 bags of milk replacer into each calf. Then wean. They should be eating at least one pound of grain per day when you wean. A calf will do better if you at least have 2. Cattle are a herd animal, and just don't do as good when raised as a single. After weaning they should have full feed grass or hay. And grain is important. The should be getting fed 1 lb of grain per 100 lds. A 400 pounder should get 4lbs. A 700 pounder should get fed 7 lbs. Etc. It's important they get fed grain every day and all the way through. Then for the last 90 days, they should be taken off of hay and grass and be full fed corn. Don't feed them nothing at all for the last 24 hours before butcher. Once they are hung, they should hang for at least 2 weeks before meat is cut up.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.