Posted by The Famous Grouse on November 07, 2018 at 10:13:42 from (97.116.16.185):
Guys, last winter my hunting farm was snowbound and the only way I could get in there was to walk the half-mile driveway in snowshoes. That got a little old by the end of winter and last year we were getting snow until late April.
My Deere 2010 (gas) with loader sits in at the farm, AND I've got tire chains for her. The chains are a nice set with the square in the middle of the pattern so they are not just loop-over chains.
However... I've never even bothered to put the chains on because her rear tires were bald as cue balls. Last thing I wanted to do is take her out and the get buried and have a tractor blocking my driveway all spring because if I got it stuck the driveway is too muddy to even try to move her until early summer.
So this year it's different because the Deere got new shoes. She's sporting a fine nearly new pair of rear tires, these are the obsolete 13.9x36 tires so finding good used ones was not easy and the tire change and fluid fill set me back over $300 NOT including the price of the tires.
Which brings me to my question. Now that I spent all this time and money on good rear tires the last thing I want to do is mess them up.
Will properly installed tire chains chew up my tires?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
