Posted by andy r on November 04, 2018 at 21:51:23 from (166.223.242.117):
The sewer pipes are running slow. Thought the septic tank might need pumping. Opened it and everything is good. Tank drain is open, but flow into the septic is very weak to no flow. Can't get a snake though from inside so I must have some roots or broken tiles outside. I see some of the original cast iron sewage pipes in the basement are getting pretty weak due to rust. The gray water pipe could be replaced as well. This is all original from about 1956. At that time the gray water was diverted around the septic and joined with the septic water down stream from the septic tank. If I redo some of these pipes in the basement it would be a great deal easier to mix the sewer lines with the waste water lines in the house and run everything through the septic. I understand this is the norm today - that gray water must be treated. Old septic systems tried to keep the waste water out because lye which was the primary detergent killed the septic bacteria. Is this the case??? Can I dump gray water into the sewer pipe anywhere or should they be combined at the exit point of the basement? Thanks for you ideas.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.