Don't get me wrong. My 6620 has been a good machine and I have had to buy very little in the way of major components for it. You guys get going a few weeks ahead of us when the weather tends to be clear, dry, and warm. Around here the second half of October on in the Great Lakes tends to have greater influence meaning cool and damp. A cylinder machine is at a disadvantage under these conditions versus a rotary. There is a parts yard about 35 miles away that has a good stock on 6620 and 7720 parts. K & J Surplus Lansing,NY. The old man is stepping back there and the son is taking over. 607-379-5185. When I took over there was a need for equipment as some did not exist. Which is to say dad shared equipment but about the time I got going a couple of the neighbors retired out so no more sharing. Most of the iron here is 1985 or older other than the JD 1750 planter and JD 980 Field Cultivator plus a couple small pieces. I don't think that we are overdone on equipment. Buying land locally is problematic unless you are an investor. Ground locally can vary production such as corn running 100-170 bushels most years and beans 20-45 bushels most years. Guys are paying like we have consistent 200 bushel corn and 65 bushel bean ground. Your BIL's mindset is right in that if you are reasonably set on equipment then a younger hungry farmer should concentrate on land. That is why I would rather buy a 1460 than 2166 so the difference can be used elsewhere.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
