Posted by Danny Prosser on October 17, 2018 at 06:50:29 from (170.141.177.62):
In Reply to: Pond Bridge posted by Danny Prosser on October 17, 2018 at 05:18:37:
Thanks for all of your ideas. It gives me some different things to look at. I'm in Tennessee and it don't get cold enough to freeze the pond hard enough to walk on it. I thought about just going out there with the boat and cutting it every so often but the older I get the harder that would be. With a bridge I could keep it cut with a weed eater. I was planning on making part of the bridge at one end on hinges to raise it up so the critters couldn't get to the goose when she's on the nest. And we could fish from it and the island to. I'm guessing at the distance so first thing I'm going to do is get an accurate measurement. the water probably isn't over 4 or 5' deep. I might can get ahold of some electrical poles to from a guy I know if the ones he has are long enough.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.