Posted by rustred on October 14, 2018 at 09:46:48 from (74.214.153.210):
In Reply to: Farmall 400 question posted by Mark Hogan on October 14, 2018 at 02:44:22:
many dont understand that the rad cores get corrosion inside from weak coolant mixtures. this plugs the cores and reduces coolant flow through the rad. you can simply remove the cap and drain down the coolant till you see the cores. if you see white corrosion in them thats your problem . from my experiences 90 percent of the time its a radiator problem. after all these tractors are over 60 years old and that is quite normal to happen. dont see how a circulating block heater can make it heat. do you have a working factory temp guage on the tractor?? normal operating temp on the guage is when the needle sits right on the U in RUN in the green. thats working in the field. you have lots of "seems" going on but nothing confermed.when you say "heating" is the coolant boiling and pushing out? retarded timing will not cause an over heating situation if the rad is good.plus you did not say if your working this tractor or just driving it around or its just sitting overheating. plus you had the valve cover off and should have set the valves at that time... there is more to it than just say they are going up and down. they need to be set at .017 hot. and yes if there is oil on the top of head running down it will be smoking when working... but that dont mean the engine is over heating.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
