Posted by Jeff in ND on October 01, 2018 at 09:32:22 from (204.54.36.245):
In Reply to: Beans 1996 vs 2018 posted by Jeff in ND on September 30, 2018 at 17:03:33:
Quoting Removed, click Modern View to see
Dad's had a cab/heater. A neighbor had one w/o though. Lots of dust in the cab, especially with oats. Kept a short handled broom in there to sweep the inside of the window! The combine and heads were bought from another farmer. Dad had the bean head (12ft?) and a 235 corn head as well as a belt pickup for windrows. Took most all day to take the reel and sickle off and install the belt pickup so about 10 acres of oats could be done and then put it all back before beans. We'd also have to take off the chopper and maybe put that back on depending how much straw was needed for the barns. We had cows/calves and hogs too. Oats was used for the hog feed.
That 45 was a big step up from a Case A6 he had prior.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.