Well, I look at it this way. Around here we have cars, trucks, tractors, motorcycles, construction equipment, field trucks (unregistered, uninsured, un-road worthy farm implements). ATV/UTV/dirt bikes, pedestrians, bicyclists, buggies, horseback riders, snowmobiles and snowplows all using the same roads. Our town road is, IIRC, 12 feet wide with no improved shoulder over much of it. Our county roads are wider, maybe 16-18 feet and most don't have a paved shoulder and many don't have in improved shoulder. State roads are much wider with a paved shoulder. We also have a lot of one lane bridges. The biggest problems I see now and saw professionally in LE is people driving with a cranial/rectal inversion, ie- head up their backside. Doesn't matter if it's the milktruck driver doing 55-60 down a town road on a foggy morning, a group of motorcycles riding 2 breast and putting one guy a couple inches off the center line or a retired college professor riding his $2500 bicycle in the roadway when he's got 6 feet of paved shoulder he could be using. We all need to slow down, drive defensively and politely and do our best under the circumstances we live with. Everybody is a horses backside at one time or another and driving seems to bring out the worst in some folks, especially if someone else causes them to have to slow down or wait a moment to pass. I know people very well that will come to a complete halt in the middle of the road to make sure a turtle gets out of the lane that get all bent out shape when they get behind a tractor and piece of equipment on a hill. (Don't tell my wife I'm talking about her!!!) If we'd all try to be a bit more considerate and slow down just a little, or get to the side of the road with the tractor (now I'm talking about my son!) instead of staying in the middle, we'd all be a bit better off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.