Posted by JD Seller on September 23, 2018 at 07:41:01 from (208.126.198.213):
While reading Davidj post below I got to thinking about how dangerous the older tractors actually are. Very few have roll guards and even fewer have seat belts if they do have a roll guard. Many have very poor brakes even when working 100% as designed. Aftermarket loaders that really can easily over load the tractors. Other attachments that are really too big for the tractors they are trying to use. Combinations of all of this make the older tractors causing serious accidents more common than newer equipment.
Then the really bad part. OLD MEN running them. LOL I know that I am one too. First off our reaction times are terrible. Second we actually take more risks than we think we do. It is all the macho/ego " I have done this a hundred times and nothing happened" thing. Third, retired fellows doing things they may not be used to doing at all. I personally know several that all had fatal accidents within months of retirement. I think it often is they might have had the tractor for years but now have time to be doing things they never did very much with them or trying to do things they should not even think about doing. They want to "save" money because they are on a "fixed" income. So you have the wrong equipment being used for many jobs.
The national numbers show that older tractors cause more deaths than newer ones. Also a disproportionate number of those killed are older men.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
