I don't want to understate how bad my joints were. When I'd get in bed at night,I'd have to prop myself up on my right elbow and relax until my shoulder popped. That was the only way I could even sleep for an hour on my side,even then the pain would wake me up after an hour. The left one wasn't so bad that I had to wait for it to pop,but again,I could only sleep on it for an hour or so until the pain woke me up. I couldn't sleep on my back or I'd stop breathing.
When I started on the elliptical,I'd have to turn my right leg just right after I got started to keep the pain in the knee down to a tolerable level. Once you start to strengthen the muscles around the joints and stop carrying so much weight around,you'll be in disbelief at how they'll heal themselves. The first two weeks I used that thing,I was literally sweating grease.
I cut 20 acres of hay yesterday,got off the tractor and on to the loader tractor,made four trips a mile up the road picking up stones out of some fencerows and bringing them home and dumping them in some ruts in front of the feed bunks where nearly 8 inches of rain have taken their toll. Three years ago,I would have hobbled my way down out of the tractor and made my way to the house with my cane then would have fallen asleep in my recliner the rest of the afternoon.
Do a search for "buy exerpeutic air elliptical". They're dirt cheap,they're rugged and they're all mechanical,so you'll be doing the work. There's no motors or anything to do it for you. And of course if it kills you,your widow won't be out too much money on it. LOL
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.