If so, disconnect the output to the carb, direct the flow to a container. Crank or start the engine, see what kind of flow you get. Should give a full stream, pulsing flow. If slow flow, dribble, air in the stream, likely the pump is bad
If the pump checks good, or there is no pump, remove the drain plug in the bottom of the carb. It should give a full stream and continue to flow (continuous flow when cranking if fuel pump equipped). If no flow or flow slows to a drip, there is not enough fuel in the carb bowl to run. Some carbs have a screen in the fuel inlet fitting, be sure it is clean.
If there is fuel in the bowl, and it still requires full choke to run, check for vacuum leaks. Not sure how the intake is configured, if it is siamesed to the exhaust it could be burned through internally. A vacuum gauge will be helpful diagnosing vacuum and valve problems. Another test, remove and ground the coil wire, opemn the throttle, hold your hand tightly over the air in of the carb, have an assistant crank the engine through. You should get a steady, firm vacuum against your hand, and be wet with gas. If little or pulsing vacuum, there is a vacuum leak or valve problem. If vacuum and no gas, there is a carb or fuel delivery problem.
You may want to revisit the internals of the carb. All fuel must pass through the main jet. Be sure the jet is clean and the adjustment needle is backed out about 2 turns. carb sitting with old gas can clog to the point of needing the passages scraped out with a wire to remove dried deposits. Get this right, fuel in the bowl, the emulsion tube in place in the venturi, and the carb will at least work well enough to run.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
