Posted by super99 on July 28, 2018 at 19:12:43 from (74.36.75.185):
I bought an old Walden Blade that I want to put on my 1850. The clamps that hold the blade to the frame are gone, I'm going to have to fab up something to use it. Not sure about finding a piece of pipe that will fit over the blade frame to make new ones, rough measurement is 4 1/4" pipe diameter. Wondering about just using a piece of heavy angle iron and weld on flanges for the bolts to go thru. Looks like all the force when pushing will be on the blade frame, the clamps just hold it in place. Has anyone had or seen one on a Oliver before? Wondering about bolting the rear of the frame to the rear axles. Oliver axles have 6 holes cast into the axles, are they strong enough to bolt up there, or do I need to put bolts outside the axles to take the strain of pushing dirt? The holes in the rear mounting plates do not match the holes in the axle, but the plates do not extend far enough past the axles to just bolt it up, looks like I will have to do some modification to the rear mount also. Is all of the push force on the axles or did they have something to fasten onto the drawbar when pushing?? I guess I never have seen one close up mounted on a tractor, just thought they looked like they would be quite the asset to move a little dirt. Chris
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.