Posted by Adirondack case guy on June 21, 2018 at 18:16:27 from (69.207.198.19):
Well I have spent the last 3 days in the woods. I have lucked out this week and have some excellent help. My first cousins grandson has been helping me. He is 14 and a real good kid. His father and mother never wed so he has bounced around a bit. His dad dropped him off Tuesday morning, and I spent a few minutes to show him how to drive my Case 831C with COM tranny and he mastered it in 5 min. He is very conscientious and really interested in tractors. Next week we will spend some time working on his dad's Case SC which is in my back yard, plus making some more firewood. He is really looking forward to working on the SC. We made and stacked a load each of the three days. 1-1/4 cord per load. 11 more loads to make, to replace what I burned last winter. I pick him up at his grandfather each morning and he stays with us until after we feed him supper each evening. He has some other things to do tomorrow and over the weekend, but he will be back next week.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
