In terms of restoration, here's a basic outline of what had to be done...
Remove and repair fuel tank, which had rust holes underneath. The larger holes were successfully welded up at Lee's Welding Workshop in Taree.
Smaller holes in the fuel tank were patched up using Magic Metal or QuickSteel.
The fuel tank was then sand blasted and a coat of primer applied. It was then de-rusted inside, and lined with a lining solution (KBS Gold Standard Tank Sealer), which was rolled around for an hour or so then let it cure for a few days.
There was a large hole in the engine block (due to water freezing in England) which was repaired by Mayric Engineering in Taree, steel plate was cut to shape and brazed into the hole.
The block still had some cracks from the brazing process (which leaked water!), which were metal stitched.
All the welsh plugs were replaced due to bad corrosion, and thus water leaks everywhere!
The steering wheel has been repainted and the timber has a fresh coat of lacquer.
The metal faces on both the exhaust/intake manifold and the vaporizer had pitting and slight warping, causing an air leak, which meant the engine would only run with full choke. Both surfaces were machined back to perfectly flat, to ensure a good seal.
The cast iron petrol starting tank had a crack, which was ground out, repaired with Magic Metal or QuickSteel, and then painted.
A new coil-box cover was sourced, and a brand new set of trembler coils installed.
All the wiring has been replaced, including timing wires, spark plug wires and battery wiring.
New linkages for the throttle and choke were fabricated and installed.
The head gasket was replaced.
The timing was out by 90 degrees, and was reset to make it fire just on Top Dead Centre on compression.
New copper fuel lines were fashioned by a member of Taree Historic Motor Club.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
