I had a shot Ford 4000 rear oil main on a purchased tractor once...salvage value sale. Oil pressure registered zero. I hoped for the best but Murphy had control and it was the worst....but that's what I paid for so why gripe?
When I moved from gas tractors to diesels what came to mind was where the wear occurs. With the higher compression, the "Bottom End" takes the beating whereby with gas the hotter combustion works over the Top End. There was one exception for me and that was the 3000 Ford purchase. It was at around 4500 hrs and PO had run it for who knows how long with the intake manifold - oil bath air filter hose off. Looking at the rest of the tractor it had seen some rough, dirty environment, service. The pistons had to be replaced along with the rings with the bottom end rework. My first diesel....I was naive at the time, paid market price, should have known that in April, in Texas, you don't need ether to start a diesel tractor. Don't care how you look at it, an education costs money. Smiley Face.
Easy enough to drop the pan, pop a main and rod cap, install some plastigauge, put it back, roll it over, pull out the gauge and you will have your answer. Probably 2 hours work at the most. If the Babbit is worn off the inserts that is a pretty good sign of the smoking gun. Doing a bottom end inframe isn't all that big of a deal....like for me an easy one man job.
On the pump you are looking at 30-50 psig....my JDs had a popoff at 30, my '60s vintage Fords run 55. As I recall cranking compression is around 400 give or take....I'd forget the pump.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.