It is possible to start from scratch. My first "farm" was a widowed neighbor who needed help with her property. She had horses and hay fields but no equipment. I got a small tractor and rake and rented a baler and haybine and cut 10 acres of hay, sold most of it to her and the rest in field to another farmer I knew. That was 3 years ago I think. Now I have 4 tractors (two small ones and two mediumish ones), all my own small bale equipment and this year paying FIL to round bale 40 acres for me. Next year some of that is going into crop. I make about $1k a year in custom work for a food plot as well (easy with the deer doing the harvest!) It's not good for income just yet, but it's a growing operation from scratch. As I said above, my FIL has been huge with the advice, and I get lots of knowledge from the forums and youtube. I work retail sales for 60+ hours a week and spend time with family and squeeze the farm in when I can. It's not an easy balance, and sometimes not balanced at all. But if someone is willing to work for passion of eventual profits and the pleasures of working the land then it can be done so long as there are little old ladies that need some help and don't like modern ag. The land I have been finding is abandoned because they won't let folks spray. Rather than try to educate them on this or that, I go with their wishes and do the best I can. Tillage equipment is so much cheaper anyhow. You gotta work niche markets where you can. Maybe I'm not successful, after all, I lose money every year. But I haven't failed yet, so that's success in my book.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
