Posted by 1957Ford600 on June 05, 2018 at 09:07:32 from (69.179.32.128):
I have a 57 Ford 600 that I converted to 12 volt years ago and it has worked great for years. I ordered a solenoid from a tractor supply but it is a four terminal rather than the old three terminal. The old one worked with the push button start which is a ground button but that no longer activates this solenoid. I know that some solenoids have a grounded base and others don't. Using an ohm meter, I have full continuity between the base and S terminal and the needle only goes half way between the base and I terminal. Also the needle goes half way between the S and I terminals. I've been told I need to run a positive lead to the S terminal and not use the I terminal at all. Is this accurate? That would mean replacing the push button which has a single terminal with one with two terminals. Rather than experiment and short things out, I would like to know if this is correct. If I don't use the I terminal, how do I run power to the coil? It may be easier to just find a coil with only three terminals, but I have four old tractors all wired differently and would like to understand how both a grounded base and non-grounded base solenoid should be wired. Thanks for your help. Russ
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
