Posted by guido on May 31, 2018 at 12:37:59 from (72.82.162.131):
Hello Tedtractor,
Just wanted to make sure you get it, as you have asked for the instructions.
Your model engine idle speed is set @ 2000 rpm's. To adjust it you simply use the idle screw. If you need to adjust the air to fuel mix ratio, here is how to for an aluminum head. Adjust the idle speed to 1750 rpm's, then carefully pry the mixture adjusting screw plastic cap-limiter. While watching the tack, turn the mixture screw both ways until the engine starts to loose rpm's. Hold the idle lever while turning the mixture screw, that way you will maintain the idle you just set at 1750 rpm's. the half way point of the number of turn is where you set the mixture screw. Put the plastic cover back on with the stop tang 1/2 way between the stops. return the engine to 2200rpm's. You can adjust the air to fuel ratio with the rpm's @ 2200, but that would be too rich, because the higher speed would require more fuel-richer setting. Let me know if you need more help,
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.