Posted by Destroked 450 on May 29, 2018 at 10:57:39 from (173.242.142.14):
In Reply to: Two Piece Crankshaft posted by Destroked 450 on May 28, 2018 at 15:00:43:
Quoting Removed, click Modern View to see
Line bore is fine, main web is ok, no damage to cap or bolts.
Slight abnormal wear on the front main bearings, no visible difference between the #1 rod bearing and the others.
Main bearings on the left are from the front main and show some abnormal wear on the outer edges compared the #3 main bearings on the right.
If the replacement crank was .010 under I'd reuse these bearings, but it's standard so new bearings where needed.
What we don't know is when the crank broke, the first indicator was 4 months after the rebuild when running the decaker in the poultry barns, the warning light blinked on and back off a couple of times when the engine was idled down.
The oil light would blink when the engine was idled at random times over the next few years and I suspected a possible defective sending unit. These engines Never have oil pressure issues or crank problems.
While tedding hay at low rpm's the warning light blinked a few times so I decided to connect a mechanical gauge just to confirm the sending unit was going bad.
Oil pressure was lower than it should be at idle so I left the gauge connected to monitor the oil pressure.
Cold pressure was 75 psi, after the engine had warmed up pressure dropped to 40 psi at operating speed and 20 psi at idle, again lower than it should have been but not alarmingly low.
Next time we ran the decker is when we knew for sure there was a problem, this machine works the tractor hard and after a while oil pressure dropped to 25 psi at operating speed and 10 psi at idle.
When I drained the oil and dropped the pan to look for a problem I was totally shocked to find the crank broke.
We put over 300 hours on the engine from the first time the warning light blinked until I dropped the pan to find a broken crank.
Since everything in the engine was in excellent condition other than the crank I can only suspect the crank had been broke the whole time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
