Posted by Hay hay hay on May 19, 2018 at 05:36:49 from (71.29.176.236):
Had some new hay in the barn on May 15th. It is usually too rainy and unpredictable in central KY to make hay until mid-June or later. We had 4 days of near 90F, low humidity and 20 MPH wind. It is straight grass hay, mostly orchard grass just out of boot stage, so it should test higher protein than later hay. Had to tedd it twice to open it up to get it dry, because it was very thick and green.
This is my "test" hay. My first cut is always a small field of 4 or 5 acres (as my Dad taught me) to test out the equipment, to see if everything works. Everything worked except the tie on the roll baler, which broke after a few bales, so I square baled the rest.
It is good, dry and pretty hay, so I sort of wish I had cut more...but the weather forecasts here are not very reliable this time of year. They forecasted a 50% chance of showers for the KY Derby (May 5th) but actually got 2.31 inches that afternoon.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.