Whut you call a expansion tank (reserve tank) is a Degas tank.
BACKGROUND OF THE INVENTION
In certain automobiles manufactured by various auto companies, the cooling system used for the engine is of the so called "closed" type wherein a plastic degas tank is provided that is physically separated from the radiator and is closed by a pressure cap of a type normally located on the radiator. The degas tank is operated under internal pressure of about 15 PSI gage and is connected to the engine and the radiator so that the coolant circulates through the degas tank. One purpose for the degas tank is to allow entrained air and gasses in the coolant to be separated from the coolant as the coolant flows through the degas tank.
Keep a check on it, it may not be a problem then it may be. I would not completely fill it worst case it will belch some coolant out. If it has the original hose I would order up new ones from GM if for nothing more than to replace all the plastic parts in the hoses THAT ARE GONNA BREAK!!!!... One overlooked problem could be the hose that goes from the top engine side tank to the radiator could be stopped up, are stopped up on the nipple at the tank are radiator. The hose is preformed 1/2" heater hose retailing for about $100 from GM... Its the only hose I make up from a roll of 1/2" heater hose I mark it and just swap it out every couple of years EZ as pie... The rest I pay the ransom fee :(...
If it has a leak there is no reason it can not be found with a pressure test... The issue with those castech cylinder heads you do not have to remove a valve cover to confirm a issue just look at the oil filter it will tell the story... Dirty filter in the pix leaking castech heads at 3K miles...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.