Interesting topic and I would have been happy selling just about any brand back in the day. As far as preferences go I would have to say John Deere back during the 1960's, 1970's, and 1980's. The closest JD dealer to us closed back in the mid-1960's and even as a kid I imagined my family taking it over and running it. The building was in town and too small for the cab equipped tractors and combines plus simply would have been too small for a 6600 or 7700 combine when they came around 1970. Therefore, it would have been necessary to go into new facilities outside of town. Probably would have had a few shortlines as well such as Badger and Glencoe. New Holland would have been nice as well and there were a couple Deere dealers that also carried New Holland. Being able to benefit from looking at it today in 2018 it may have not been wise to take on NH as a Deere dealer in the mid-1960's as the franchise would most likely have been pulled after the Ford New Holland merger during 1986 so somebody else would have benefitted from all your work building up New Holland in your territory. Being able to work with cash to get started would have made life fairly nice versus coming up by the bootstraps.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
