Don't have any 4x5s (886# if comparable 5x6 weighs in at 1600). I do have some 4x6's that will easily come in at 1280# and I can lift (rear 3 pt system) and transport them with my '63 Ford 2000D (30 hp, weighing in at around 3500#) with no front end weights......however the front end is light, still steerable but light. Having your brake levers separated and brakes in good working order a plus.
Years ago I had a '74 International 464 (45 hp) gasser ant thought I was going to lift a 5x6. Front end came right off the ground before I even got started in the attempt to lift. Solution was 4 ea, 2' railroad "siding rails" on a frame I made out front.
I have hauled 5x6's with my Ford also but for that I made a front bracket and loaded 6 solid concrete blocks (6x8x12) in the bracket which was plenty to keep the wheels on the ground.
The problem is not the 3 pt lift capacity, it's keeping the front wheels on the ground.
My guess is that a 30 hp will be plenty. If not you can always add weight to the front end. 30 hp should get the forks up high enough off the ground to transport that bale over varying terrain without bottoming out like would happen on a low hp tractor with a 3 pt that rides close to the ground.......like my Brabson 2400 which weighs in at around 1800 and the rear axle is only 16# off the ground.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
