Posted by oldproudvet on February 25, 2018 at 07:01:19 from (206.188.253.91):
In Reply to: Best round baler posted by Greenismeen on February 24, 2018 at 18:26:52:
I've used a NW 851 chain baler for 15 years now. Once adjusted they make a bale, very inexpensively. Parts balers are cheap, NH carries every part I've ever needed. Take a look at the apron chains, from underneath were you see how they're adjusted. Find one complete and with good chains and you're set. Keep the cross bars tight on the chains. raise the hood, rig a tool and rotate the chain around tightening the 4 bolts on ea bar. You'll find missing bolts, loose bolts etc. One those bars coming loose is usually what relegates the baler to the parts row. Good, inexpensive baler, all over the place (at least here in west central MN). My 2 bits. Guys all have they're favorites and they are all good. Whatever you end up with take the time to figure out how everything works, and you'll see what to maintain etc etc
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.