Posted by flembo on February 12, 2018 at 03:07:00 from (69.95.213.9):
I was having a problem on cold day's with my starter grinding on the first attempt only, each day. I assumed the starter was turning before the gear was fully forward probably due to a sticky Solenoid so without taking the starter off I took the solenoid screws out and seperated it enough to spray some wd40 into the drive end. It still ground on first try so I used my salamander heater directly on the starter for about 5 min. and it started every time with no grinding. Yesterday I had some time so I pulled the starter and took the solenoid completely apart and cleaned it good wiped the bore out and used scotch brite on the plunger put it back together and it started fine and again this morning. It was only in the 30's this morning so Hopefully it will work in cold weather. I know wd 40 aint the best should I use something different as a lube that won't thickenup to much in cold weather? I am open for suggestions.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.