Posted by carvel minne farmer on January 09, 2018 at 15:22:39 from (207.228.78.200):
In Reply to: thinking shop. posted by Brent Zappe on January 09, 2018 at 08:07:52:
brent my metal shop is a u.f.a. building (united farmers of alberta) this building is on sale every spring, it is a machinery storage shed, ploe construction 6" x6" posts with 2 x 4 strapping horizontal inside and out. comes with sliding doors, I got them to swap out the sliding doors for a 12 x 12 overhead door. the cost of the package in 2004 was $14,500.00 and another $8,000. for the crew to come out and build it to the lockup stage. I then spent the next 4 years finishing the inside nights and weekends, installing water and sewer system, wiring, cement floor, insulation, 9"in the walls and 28" in the ceiling, plumbing, hotwater system, pipeing in air all around the shop, and finished the inside walls with the same metal sheets as the outside. I estimate I now have close to $100,000. total into it with me doing the work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.