Posted by Adirondack case guy on January 01, 2018 at 17:19:39 from (69.207.198.19):
If you have been following, I have been fabricating swing out tool carriers for my Case 431T tractor and firewood processor. I went down in the cellar to my wood working shop and sawed and planned some Ash rough sawn boards to make scabbards to carry my two saws on the fold out tool frames that I built onto my tractor. I also fabed up a mount for a vise to hold the saws when they need sharpening, and mtg. brackets for a crow bar, pickaroon, ax, and splitting maul. I fabed up a mount for a small vise on the RH fold out to clamp my saws in to sharpen them. That will be a big improvement over the old drive in a block bar clamp that I tried. Some of the brackets are just clamped in place to make sure they will work. I will put finishing touches/mods on them and weld them in place tomorrow. That should wrap up the tool carriers. Then back to finishing up the 2 post canopy. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
