Lots of debate because every state is different and every state's interpretation is different. Kentucky actually had to create a 26000 pound farm plate because Illinois (youre within the 150 air mile radius at the grain terminals on the Ohio River) required extra stuff for a standard KY pickup truck farm plate (38,000 plus 10% allowance). Bottom line is be real sure about each state you drive in, and don't worry about the rest. Even though its federal, so long as you do not enter interstate commerce you are governed by your home state's rules. That's why one of the questions on your DOT number application is if you interstate or intra state only. I've got an unrestricted CDL class B but do not have interstate operating authority (I used to but the headaches were way too much, fuel permits, log books, electronic log books). The only reason I keep the CDL is for local hauls of gravel which for some odd reason KY doesn't exempt. We run a fleet of trucks in state, 6 drivers, 10 trucks, from half ton pickups to 18 wheelers. Everything licensed with 38,000 pound Ky standard farm plates except one road tractor and its 80,000 pound farm limited. I'm the only CDL holder, (everyone has medical cards though, for trailers 10,000 pounds and over) but we operate in state only. So, I can give you the back and forth of Kentucky and the border states within 150 miles but that's it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
