My 16x6 tandem 3250# axles (from memory), 700x15 8 ply bias tires was built in 1979 for me, just plain ole flat deck with an angle iron rail around it about 10" off the deck with fenders. It came with 2x10 painted pine. Somewhere along the way I got some soft spots and decided to redo it. Was easy as the rear of the deck was held in place with a welded piece of angle iron. With that off and the cross member bolts out it was a nobrainer to get the boards out.
In shopping for replacement boards I bought treated 2x6s as they were cheap and couldn't find any 2x10s treated......it WAS going to get treated lumber. Over the years I have mopped it with old crankcase oil a few, not many, times. The under carirage was replaced 15-20 years ago with a kit for about 25 bucks with shackles, bolts and nuts and all the piddly stuff that wears out when no zerks are built into the design. Didn't need replacing but I wanted to inspect it and if I were going to tear it apart to do that I might as well just replace it.
The trailer has spent it's life sitting out in the weather and I keep the tires shielded from direct sunlight. Tires are Shield Brand, bought for $40 ea, cash and carry, and have been on there for at least 15 years, maybe more. There are ZERO signs of any cracking on any of the tires and it is seldom used so there must have been a lot of plasticizers in the tire when built to keep the rubber soft. I never had a set of tires survive the way these have. I did add home-made ramps to it as I have hauled tractors on it. Biggest was a Ford 4600 and it handled it just fine.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
