Posted by Zachary Hoyt on December 16, 2017 at 08:10:34 from (192.182.201.116):
I have made what I think may be the ugliest farm implement since the archetypal mud fence, but it works pretty well so far. This summer I finally taught myself to weld a little bit with an old AC stick welder. A friend loaned me a book he had from a course in farm welding and metalwork. I bought a strange trailer at an auction for $25 and cut 2 feet out of the top of the arched frame and added 1 foot to the bottom on each side, and then used the tongue that had come on the trailer. At first I used an old piece of pipe I had on hand for the boom, but on the second log I was carrying I bent the pipe so I made a new boom from the side rails of an Allis WC that I had parted out a few years ago. The cylinder and hose are borrowed from the haybine. I can lift the whole log a few inches off the ground, which keeps the log cleaner and avoids making ruts. Some of the logs I have carried have weighed over a ton according to the online log weight calculator, but of course that's just an estimate. It's been a fun project and being able to weld has made a lot of repairs easier and faster. Around here we have two people who weld that I know of, but one is a very heavy drinker and somewhat unreliable and the other one has a day job at the boiler factory and gets booked up for a week or two out a lot of the time. I know my welding has a long way to go, but at least it seems to be holding so far and I hope to get better eventually. Zach
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
