Any chance you can get the original starter back and compare it to the replacements.
Off topic but the same problem, I worked on a 65 ford with a 352 it ate starter drives up the final fix was I was lucky enoufh to have a original starter off a 390 (same set up as the 352). I never could find a replacement that fit like the original end frame off a original starter.
It went a little deeper than that tho, a starter bolt has been drilled and heli-coiled at some point in its lifetime the bolt hole was crocked. It had a Cruise-o-matic I just happen to have a bell housing and the spacer plate that goes between the engine and transmission all in said and done NO aftermarket starter fit correctly...
Don't hold me to this I think the plate tween the engine and trans aligns the starter and That's IT, its a simple set up and a beach to try and get a handle on starter drive mesh to the flywheel...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.