I am the original poster and want to follow up with additional details since I have my new parts now. Remember when my hydraulic failure occurred, ends up the splines in the crankshaft pulley mounted hub had completely failed and allowed the drive shaft to move towards the engine. I can see the shiny place on the crank pulley bolt head. This drive shaft retraction left little engagement on the pump input shaft and buggered up the first ½" of splines on the pump shaft. Thinking this will be OK IF I can assemble with fully engagement of splines throughout assembly. The picture shows the pump, coupling, drive shaft and hub on a table top with full engagement at each joint. The threaded rod from the pump mounting plate to the first nut represents the distance from the crankshaft pulley face to the inside of the pump mounting plate it is bumped up to. My full engagement assembly is short by 5/8". In case someone wonders, the drive shaft is 13 1/2" long just like the original. I can fix this by adding spacers between the hub and crankshaft pulley; thinking ½" of spacer to leave 1/8" of play. Of course assembling everything in place will be harder to confirm amount of engagement at each joint. Table Top assembly was easy because I can "see" all of it. Am I the only person to run in to this trying to keep everything engaged and span the fixed distance? I don't want to ruin anything else. If this should be in the hydraulic section can I move it or would a moderator need to move it? thanks
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
