Posted by pete 23 on November 29, 2017 at 11:00:38 from (50.33.30.135):
In Reply to: Rippoff by design??? posted by Eldon (WA) on November 28, 2017 at 17:06:14:
I just glanced over this subject yesterday as I am not a truck person. Today, read it and replies and finally realized what you are talking about. You have a trailer with it's own battery on it to operate a dump operation. Along with that you have a factory hookup that provides a system to keep that trailer battery charged. So, when you use the dump that voltage on that trailer battery is going to fall below normal alternator charging voltage , thus, the alternator goes to a high rate of charge to maintain charging voltage. I don't know how much current that dump draws when activated but it could very well put that alternator into a charge rate of 50 amperes or more. No way a 30 amp fuse set up sufficient. I would hook a relay up so that anytime you power up the dump the relay disconnects the circuit to that fuse. It would be rare that your trailer battery would require more than the fused 30 amp circuit to recharge it and in that case, that fuse would protect your wiring so you could alternately recharge battery or replace it. Then, as far as a different style fuse, you would have to make sure it's contact points were sufficient and also, I would bet that original style fuse is a slow blow designed to take a over flow for an instant before it blows.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.