Posted by MarkB_MI on November 29, 2017 at 03:26:26 from (174.230.134.129):
In Reply to: Rippoff by design??? posted by Eldon (WA) on November 28, 2017 at 17:06:14:
It's not some diabolical plot. The engineer's challenge is to squeeze ten pounds of potatoes in a five-pound bag. Each year, the electrical content of vehicles goes up, while the room for it stays the same or gets smaller. Whoever designed that fuse panel was told how big it could be, how many circuits it would have and how much current each of those circuits must carry. Given those constraints, the engineer is forced to use fuses small enough that they'll all fit. The likelihood of the trailer fuse blowing was most likely not a consideration at all. And let's not forget that those fuses aren't cheap for the manufacturer, either, even though they're buying a hundred thousand at a time. (The panel is most likely designed and built by a supplier; they pass their cost on to the OEM, but suppliers are always under pressure to bring their component prices down.)
If it's any consolation, the price of those fuses will come down over time as they become more common.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.