I Just found one of your posts on this issue in combine talk .. DieselTech,You did indeed Address that Rascal and i stand corrected . reading Your post does correlate with my problem ,You have Always tried to help Me and i Appreciate that so much ,Thank You ,And Thanks to all others that offered their stories to try to match my problem and help me learn more,. but, it was difficult for me to understand the function of each line. Until i understood the travel traffic of the Fuel it was all confusion to Me .once i took the time to learn it i was home free ,I had looked at that banjo fitting before and checked for a relief and finding none i wondered why the hole in the screw if their was no relief ??. That hole is so small i could not see it except under brite lite .Golly that is difinately The ACHILLES HEEL of a Perkins motor if i ever saw one..one spec of dirt getting past the fuel And The Pump can be TOAST .It seems incredible to me that such a small hole would be adequate to return fuel and avoid over pressuring the injector pump .. but there it is ,From Now on if i ever hear that motor stammerpuft again , I will chek that damfitting ,. AGAIN Thanks , for the Help .
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.