Posted by Adirondack case guy on September 21, 2017 at 16:40:52 from (69.207.198.19):
As most of you know, I have been using my little wood trailer to bring home my firewood, and have been stacking the wood above the racks. Quit time consuming. Today I decided to take my new trailer that I built last winter, to the woods and load it. I had a lot of big heavy blocks at this landing that I chose not to try lifting, so the jib pole on the splitter got a real workout today also. It took me an hour less to fill the big trailer, as the wood just tumbled off the elevator with minimal rearranging, and I had lots of smaller rounds that didn't require splitting and I tossed them directly on the trailer to round out the top of the load. I won't know how this load compares to the 1.4 cord loads that I stack on the smaller trailer, until I unload and stack it. I have yet to repair the 4x36" lift cylinder, so the hour that I gained in loading it will likely be offset when unloading and stacking it. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.