Posted by RBoots on September 18, 2017 at 20:21:53 from (173.241.113.101):
Was in Gulf Shores AL last night after hauling a load of equipment down, and was waiting for the rest of the crew to show up. Went up to where they were setting up for some sort of a fair at the Baldwin County Fairgrounds to kill some time. Had gone by and seen some tractors there, so went and checked it out. Talked to a real nice older fellow about red dirt, Oliver tractors, and growing cotton and Peanuts. Very interesting, know nothing about that stuff being from MI. Didn't take pictures of all the tractors there, but took a few I liked. Didn't get there until about 730 PM, so I was surprised anyone was still around there. Left for MI at 830 pm, got home about 230 this afternoon. Good ride, got to talk to lots more of them friendly southerners, and saw a lot of real nice country on the 2 lane roads through rural Tennessee and Alabama. Man was it hot and humid there. Also tried some boiled peanuts; sick!! Not sure how they got the tractors parked vertical and stay that way in some of the pictures... I've about had it trying to get the pictures to post straight, no rhyme or reason to it. Never used to have a problem with it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
