Posted by sotxbill on September 16, 2017 at 20:44:33 from (104.5.24.112):
In Reply to: Ford 2000 Overheating posted by fredkotewa on September 15, 2017 at 13:17:49:
okay,, assuming you have a gas model with the thermostat mounted on the front edge of the intake manifold... That model MUST HAVE a tiny bleed hole in the thermostat flange, or the hot water will never get close enough to the thermostat to open. You can either buy a thermostat with the tiny bleed hole or drill one your self. Must in the flange close enough to the center that it will flow a tiny bit of water, even when the thermostat is closed,, this way the water movement will allow hot water to get near the thermostat, and then open it. If the hole is to near the edge, the housing will cover it, and not let the tiny bit of water flow through. This hole will also allow you to bleed all the air out and get the water next to the thermostat. Some models are more sensitive to this, and the gas model 3cy engine is EXTREMELY sensitive to this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.