Check around your area to see if these's anyone that knows how to hammer a circle saw blade.
I don't have any experience with 40-42" blades but can tell you that if a 56" blade isn't properly hammered it will not cut useable lumber and can be very dangerous.
I'm more accustomed to production style 56" circle mills with 36" top saws where constant blade speed is a necessity for good lumber, so I don't know if the smaller blades are more forgiving to speed changes or if one just has to slow down and crawl through the log.
1st sawmill I worked at had me turning logs on a Frick 01 hand set stick mill powered by a old J Cummins. Turning logs with a cant hook was hard work but it was better than off bearing slabs.
Not a lot of old hobby mills around here any more after scrape iron hit over $200 per ton a few years ago.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.