If you have a plow that is properly sized for the tractor it will work fine. Implement dealers used to like to sell big iron, so they'd sell the largest plow a tractor could pull and extra weights so a tractor would lug in a low gear with a lot of smoke and tire slippage (10 to 20 percent tire slippage instead of 5 to 10 percent). You could actually get more done on less fuel with a smaller plow moving at 5+ MPH with half the tire slippage, but that was far less impressive than pulling the bigger plow.
Often it comes down to estimating how much time you have to complete a job and then using equipment that can get the job done in that amount of time. A rough guide for how many acres can be covered per hour is: "Width in feet" multiplied by "Speed in miles per hour" divided by ten = acres per hour. (use actual ground speed allowing for tire slippage) This works out to roughly 70 percent efficiency, tillage efficiency will be a little better than 70 percent, harvest and planting will be below 70 percent efficiency.
If your MF135 can pull 3-12 plow at 3.5 MPH actual ground speed: (3 bottoms x 12 inches/12 inches per foot) X 3.5 MPH divided by 10 = 1.05 or about 1 acre per hour. 10 acre divided by 1 acre per hour = 10 hours to plow your 10 acre field.
If your 756 can pull a 4-16 plow at 4.5 MPH: (4 bottoms x 16 inches/12 inches per foot) X 4.5 MPH divided by 10 = 2.4 acres per hour. 10 acres divided by 2.4 acre per hour = 4.2 hours
If you really want to, you could calculate the cost of fuel saved using the smaller tractor verses your additional labor cost, but if you enjoy the extra seat time plowing, it does not matter. Have fun!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
