Posted by Brent Zappe on July 20, 2017 at 07:44:11 from (104.192.88.65):
In Reply to: Magneto help posted by Lumbersawyer on July 19, 2017 at 19:55:56:
When I put a screw driver up to mine it does not stay. Sorry this answer is no help to me to help you. I am not trying to joke around I am only trying to understand what you have done to your Magneto. You stated it is not firing a spark did you pull the magneto off the engine and then put it back on? If so did you put it back on time and made Shure the Magneto is on time with the engine? Some time Magnetos can be hard to put back on the engine because when you think they are in time they can be off after they snap and send the spark to cylinder. Thus means if it snaps and send a spark if this is off it will spark late. This means that the spark than is a back fire and it will not run meaning the amount of timing is off. Means than you have to determine the degrees it takes for the snap to happen to make it fire on time. I should know I have pulled and fix many Magnetos Thus understanding most people do fail on installing them. They forget that you have ex mark degrees for that snapping to happen before the spark. I might add the contact between the rotor and the cap must be in line when firing the spark to that cylinder. You might have a good magneto but it may not be on time. Some thing to think about.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
