Posted by Bruce from Can. on July 16, 2017 at 11:16:16 from (76.69.28.6):
In Reply to: 489 Haybine guards posted by Dave8N in Pa on July 16, 2017 at 08:53:52:
If you are having trouble sliding the knife in and out my advice is this . Go to one end of the header , and look down the length of the knife. What you most probably will see is that some guards are bent up , and some bent down from hitting rocks. You can straighten these bent guards back into their proper position with a guard bender. Now your next question will be ,"where can I get a guard bender?" That is simple, you make one. All you need is to find a length of pipe, about 4 feet long , that will fit easily over the front of the guard, while the guard is still fastened on to the haybine. Then cut a piece off of the pipe about 6 inches long, and weld it to the remaining long piece of pipe, about 4-6 inches from the end of the pipe. That is your guard bender. Now just establish which guard is bent up, slip the shorter pipe over the end of the guard, and the longer end will go under the guard. Now press down , bending the guard back into the appropriate position. If the guard is bent down , reverse the procedure. In most cases , it is not really the guard that is bent, but the place on the header where the guard is bolted on that is bent. The knife rubbing against the knife will make it "run hard". And if some are bent up while others are bent down , just makes it that much harder as you can imagine. If I have only made you more confused, I could take a picture of a guard bender that I made many years ago , and post it for you. Bruce
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
