Posted by JD Seller on July 12, 2017 at 16:34:54 from (208.126.196.24):
Monday I was cleaning up around the shop at the farm. The pallet racking on the one wall is close to the overhead door. To get pallets in the top tier you have to have the overhead door down for the ceiling clearance. I was only setting one pallet up so I only ran the door down a little bit. So being a sixteen foot tall door it does not catch your eye walking in and out of it. About 10 minutes later I was backing the one combine in so we can get it switched over for oats. I was watching the ground level because with the duals on it only misses the sides of the door by a few inches on each side. WHAM!!!! I hit the over head door with the bin extension. Wrecked the bottom panel and twisted the door track bad. Just installed the door last year. Cost me right at $5K but I finally had a good. well made door. Not for long!!! I got it to where it will work but it sure is not pretty. Door guys coming out next week to see what I need to fix it right. ARGGGGGGGGGG
Then to day I was taking a mixing auger to have a new one made. Chain slipped off and just barely hit the back corner of the rear window on my pickup. BOOM!!!!! Safety glass every where. This window has a power slider in it. Looks like $5-6 hundred plus installation to replace it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
