Shoot... They are easy to mount. I'm older than "old" and do my own tire work. The hard part is breaking loose the old tire from a rusty rim. You may need to repair the rim especially if it is eaten away by the valve stem. Tractor rims are just common steel and can be welded by your method of choice. Just be sure to have ALL the rubber away from any welding. It burns easily and is very difficult to extinguish. The last tire I mounted was a 14.9 x 28, maybe 2 months ago. I had bought a pail of tire grease from Miller tire (kind of like thick vasoline) and that stuff was better than any other tire lube I've used in the last 50 years. The bigger the rim diameter, the easier the tire goes on. I've done it both ways, with the wheel still on the tractor, and with the rim laying flat of the ground. If lifting the weight of the finished tire and rim is too much to handle (or you have wheel weights) then the "on the tractor" method makes more sense. Of course it is best to be near your air compressor. I usually use 3 tire irons or spoons maybe 20+ inches long.
Best of luck!
Paul in MN
P.S. Old:I have a daughter living near you, a few miles south of Richland right on I 44. She and her husband are getting into farming their 41 acre place and some adjacent land for horse hay. Her husband is attached to Ft Leonard Wood as a Physical Therapy medic. He has had 5 deployments during his career, and is partially disabled due to battle events in Iraq. You might enjoy getting together with him. I'll give you his phone # if you want to email me.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
