Well my acquired, potential drive to work, used Nova 2 door hatch back 6 cyl. had the integrated heat/intake manifold. Was going to work one day and it cracked putting 50/50 in about #3. Sitting stuck in the center of 3 lanes of traffic, all of a sudden the car filled with this funny smelling fog. Completely engulfed me and scared the begeebies out of me. At least the people adjacent to me on the curb side wiggled enough room to let me out (get me out of their breathing/seeing space) and I hit the ditch. Had no earthly idea what was going on till later. That is where I learned the benefit of adding water to a combustion chamber. By the time I got the head off, the crown on #3 piston was spotless and that was before unleaded gas as I recall.
I got through that and nursed it back home that night. Remembered the son had an old Chevy truck he got from a friend. Checked and the intake manifold and separate head (conventional fashion) were intact and decent. Wondered if it would backfit. It did a so much for Chevy's wonderful money saving idea.
That was the same 6 I was putting an electronic ignition in and had the carb intake pipe disconnected and the top off the distributor or something like that....been 25 years or so.....any way i rolled the engine to set up a cylinder for firing and the distributor sparked just as the fuel pump shot a squirt of gas across it and presto.....fire in the hold! Took me a couple of seconds to get my wits but did and grabbed a fire extinguisher hanging on the wall....thank goodness I had one and put it out before anything got damaged beyond repair.
Gave it to the oldest boy and he sold it to a friend who rolled it and killed himself.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
